IMPERIAL PIPE CORPORATION

Thermolene Pipe
Thermolene Fitting

Elbow 30°
 Elbow 45°
 Elbow 60°
     
Elbow 90°
 Tee
 Cross
     
Lateral
     
Nom. Dia. 30° Elbow 45° Elbow 60° Elbow 90° Elbow Tee or Cross Lateral
(mm) (in) L (in) S (in) L (in) S (in) L (in) S (in) L (in) S (in) L (in) S (in) Y (in) E (in) X (in)
90 3 6.75 21 8 23.5 9 23.5 11 26 9 24 17 9.5 18
100 4 8.5 23 8.5 24.5 9.5 24.75 12 28 10 25 18 12 18
160 6 9.75 25.75 9.75 26.5 11 28 15 33 12 28 24 16 18
200 8 11 26.5 11 29.5 11.75 29.5 18 36 14 30 30 20 18
250 10 12.25 33.25 12.25 35.25 14.5 36.5 21 44 15 37 36 24 22
280 - 12.75 34 12.75 37.25 15.25 37.5 22.5 46 16.5 38 39 26 22
315 12 13.5 35.5 13.5 39 16.75 39.5 24 49 18 40 42 28 22
350 14 14.75 36.5 14.75 40.5 18 41.25 27 52 20 42 48 32 24
400 16 16 42.5 16 46.5 19.75 48 30 60 22 48 54 36 28
450 18 17.25 44.25 17.25 48.5 21.5 50.25 33 64 24 51 60 40 28

Note: Reducing tees, crosses and laterals are also available.

A complete line of elbows, tees, crosses, reducers, flanges and back-up rings are available to complete your Thermolene system.

Fabricated fittings are produced from mitred sections of pipe, heat fused together to make elbows, tees, crosses, and laterals. Concentrated stresses can be higher in fitting configurations because of their internal geometry, and as a result mitred fittings for pressure applications should be fiberglass reinforced (CGSB41-GP-22).

Molded fitting are also available through 8".

For the fittings listed below, dimension «S» is for plain end, used in butt fusion, and dimension «L» is for stub ends, used in flange assemblies.