Jeamar Winches Product Catalog

Terms and Conditions

Jeamar Winches Warranty
Jeamar Winches warrants its products against defects in material and workmanship for a period of one year from date of purchase to the original purchaser. No responsibility will be assumed by Jeamar Winches for repair or parts other than those carried out or supplied by Jeamar Winches.

This warranty is limited to replacement or repair of parts at Jeamar Winches option. It does not cover damages or defects due to normal wear and tear, misuse, alteration or neglect.

No other warranty is expressed or implied and the company assumes no responsibility for consequential damage arising from the failure of the products for any reason whatsoever, nor does it assume responsibility for improper storage or handling by customer or user prior to placing into
service.

The purchaser shall determine the suitability of the product for his use and assumes all risk and liability in connection therewith.

Jeamar Returned Goods Policy
Upon written authorization, Jeamar products can be returned for credit, provided merchandise is unused and complete. The customer pays freight back and a re-stocking charge of 25 percent will be assessed. If merchandise of relatively equal value is purchased in exchange, the re-stocking charge is 15 percent.

Warnings
Ensure the correct equipment is obtained and installed for the application.

Ratings shown in Jeamar literature are applicable only to new products.

Working load limits shown are the maximum load the product is authorized to support under normal environmental conditions. Shock loading and abnormal conditions must be taken into account when selecting products.

In general, products displayed in Jeamar literature are used as parts of a system. As a result, we can only recommend within the working load limits, or other stated limitations, the use of products for this purpose.

Working load limits or safety factors for each Jeamar product may be affected by wear, misuse or environmental conditions. Regular inspections must be conducted to ensure the equipment continues to meet the published standard.

Avoid shock loads
These are transient loads that exceed the steady- state load. Shock loads are caused by sudden accelerations, usually due to unrestrained loads, swing loads, jerking, or impacting of the load. The working load limit may well be exceeded under these conditions.

Welding to any Jeamar products can be hazardous and should only be implemented after written permission from Jeamar.

Jeamar products are sold on the strict understanding that all product selection is the full responsibility of the purchaser. Jeamar accepts no liability for the use, misuse or incorrect application of its products.

Jeamar products shown in this catalogue are not approved for lifting, lowering or moving people.

Definitions
Working Load Limit (WLL)
This is the maximum load that can be imposed on the product under any set of conditions. The working load limit is calculated based on a steady state load applied in a straight-line pull.

Ultimate Load
This is the predicted average load at which the product will fail.